Jeld-wen JII103 Bifold Doors Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

for Bifold Doors (JII103)

Read these installation instructions thoroughly before beginning. They

are designed to work in most existing applications. However, existing

conditions may require changes to these instructions. If changes are

needed, they are made at the installer’s risk. For installations other than

indicated in these instructions, contact a building professional.

Thank you for selecting JELD-WEN

products. Attached are

JELD-WEN’s recommended installation instructions for hollow

and solid core bifold doors. Bifolds are designed for fast and

easy installation and adjustment using common tools.

Note to Installer: Provide a copy of these instructions to the building

owner. By installing this product, you acknowledge the terms and

conditions of the limited warranty as part of the terms of the sale.

GLOSSARY

Finished Opening

The resulting opening after any trim work is completed. Measure these

dimensions for proper door  tting.

Lead Door

The panel or section without the pivoting hardware. On four panel

assemblies, these are the two that meet in the middle.

Pivot Door

The panel or section that contains the pivoting hardware and supports

the weight of the door assembly.

IMPORTANT INFORMATION AND GLOSSARY

SAFETY AND HANDLING

• Read and fully understand ALL manufacturers’ instructions before

beginning.

• Use safe lifting techniques.

• Wear protective gear (e.g. safety glasses, gloves, ear protection, etc.).

• Operate hand/power tools safely and follow manufacturer’s operating

instructions.

• Heed material manufacturers’ handling and application instructions.

• Store doors in a dry, well-ventilated building and on a  at and level

surface.

Estimated Install

Time

First Time: 1 hr

Experienced:

½ hr

NEEDED MATERIALS AND TOOLS

FINISHING MATERIALS

Note! Follow all material manufacturers’ instructions for proper use

and compatibility.

TOOLS

• Hammer (applies only to certain hardware)

• Drill with bits

• Screwdrivers

• Safety glasses

• Tape measure

• Do not subject interior doors to extremes of heat and/or humidity.

Prolonged exposure may cause damage. Buildings where humidity

and temperature are controlled provide the best storage facilities

(recommended conditions 30%-50% Relative Humidity and 50°F to

90°F).

• Do not install doors in buildings that have wet plaster or cement

unless they have been properly  nished. Do not store doors in

buildings with excessive moisture content - HVAC systems should be

operating and balanced. Avoid sudden changes such as forced heat

to dry out a building. Doors should not be delivered to the job site

or installed until concrete  oors, foundation, plaster or drywall are

cured.

• Doors should always be handled with clean hands or while wearing

clean gloves.

• Doors should be lifted and carried when being moved, not dragged

across one another.

• Finish all six sides (both sides and all four edges) of the door slab,

including cutouts for hardware. Failure to  nish all six sides may

result in the denial of warranty claims for operational or performance

problems.

IF INJURY OCCURS, IMMEDIATELY SEEK MEDICAL ATTENTION!

• Rubber gloves

• Paint brush

• Sandpaper

• Drop cloth

• Paint (and primer for raw

wood doors) or stain and wood

conditioner

• Wood putty

1 2 3 4 5 6 7 8 9

Résumé du contenu

Page 1 - NEEDED MATERIALS AND TOOLS

INSTALLATION INSTRUCTIONSfor Bifold Doors (JII103)Read these installation instructions thoroughly before beginning. They are designed to work in most

Page 2

INSTALLATION INSTRUCTIONS for Bifold Doors (JII103)2INSPECT FINISHED OPENING, REMOVE PACKAGING AND INSPECT DOORINSPECT FINISHED OPENING• The width si

Page 3 - IDENTIFY HARDWARE TYPE

INSTALLATION INSTRUCTIONS for Bifold Doors (JII103)3IDENTIFY HARDWARE TYPE2Open the hardware pack and compare the contents to the images on this page.

Page 4 - INSTALLATION FOR TYPE A1 - A4

INSTALLATION INSTRUCTIONS for Bifold Doors (JII103)4A. Upper pivot pinB. Guide for trackC. Snugger or slide guideD. Lower pivot pin E. Lower bracketF.

Page 5 - INSTALLATION FOR TYPE B

INSTALLATION INSTRUCTIONS for Bifold Doors (JII103)5INSTALLATION FOR TYPE B4A. Upper pivot pinB. Guide for trackC. SnuggerD. KnobE. Lower pivot pinF.

Page 6 - INSTALLATION FOR TYPE C

INSTALLATION INSTRUCTIONS for Bifold Doors (JII103)6INSTALLATION FOR TYPE C5A. Upper pivot pinB. Hanger with T-nutC. SnuggerD. Top pivot bracketE. Low

Page 7 - INSTALLATION FOR TYPE D

INSTALLATION INSTRUCTIONS for Bifold Doors (JII103)7INSTALLATION FOR TYPE D6A. Upper pivot pinB. Guide for trackC. SnuggerD. KnobE. Lower pivot pinF.

Page 8 - INSTALLATION FOR TYPE E

INSTALLATION INSTRUCTIONS for Bifold Doors (JII103)8INSTALLATION FOR TYPE E7A. Upper pivot plate (2)B. HangerC. SnuggerD. KnobE. Lower pivot pinF. Low

Page 9 - COMPLETE INSTALLATION

Commentaires sur ces manuels

Pas de commentaire

Jeld-wen JII103 Bifold Doors Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la maison Jeld-wen JII103 Bifold Doors. JELD-WEN JII103 Bifold Doors User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Jeld-wen JII103 Bifold Doors